Supply Symbols GND, VCC, 0V, +5V, -5V, etc. Please keep in mind, that these devices are necessary for the automatic wiring of the supply signals. The pin name defined in the symbol is identical to the net which is to be wired automatically. In this library the device names are the same as the pin names of the symbols, therefore the correct signal names appear next to the supply symbols in the schematic. <author>Created by librarian@cadsoft.de</author> >VALUE SUPPLY SYMBOL Supply Symbols GND, VCC, 0V, +5V, -5V, etc. Please keep in mind, that these devices are necessary for the automatic wiring of the supply signals. The pin name defined in the symbol is identical to the net which is to be wired automatically. In this library the device names are the same as the pin names of the symbols, therefore the correct signal names appear next to the supply symbols in the schematic. <author>Created by librarian@cadsoft.de</author> >VALUE >VALUE SUPPLY SYMBOL SUPPLY SYMBOL TEST PAD >NAME >VALUE >TP_SIGNAL_NAME RESISTOR >NAME >VALUE CAPACITOR >NAME >VALUE >NAME >VALUE CL-505S-X-SD-T >NAME QFN 32 5 x 5 mm Source: http://datasheets.maxim-ic.com/en/ds/MAX7042.pdf >VALUE >NAME >NAME >VALUE >NAME Snaptron BL dome >NAME >VALUE >NAME >VALUE Molex NFC coil, PN: 1462360101 >NAME >VALUE TEST PAD RESISTOR CAPACITOR CL-505S-X-SD-T QFN 32 5 x 5 mm Source: http://datasheets.maxim-ic.com/en/ds/MAX7042.pdf Snaptron BL dome Molex NFC coil, PN: 1462360101 >NAME >NAME >VALUE SpiceOrder 1 SpiceOrder 2 >NAME >VALUE SpiceOrder 1 SpiceOrder 2 >NAME >VALUE >NAME >VALUE >NAME >VALUE >NAME >VALUE >NAME >VALUE >NAME >VALUE >NAME >VALUE EAST1616RGBA3 CMOS Low Dropout Regulator, 300 mA 3.3V, Active Discharge Jumpers <author>Created by librarian@cadsoft.de</author> Solder jumper >NAME >VALUE Solder jumper >NAME >VALUE Solder jumper Solder jumper >NAME >VALUE SMD solder JUMPER Since Version 8.2, EAGLE supports online libraries. The ids of those online libraries will not be understood (or retained) with this version. Since Version 8.3, EAGLE supports URNs for individual library assets (packages, symbols, and devices). The URNs of those assets will not be understood (or retained) with this version. Since Version 8.3, EAGLE supports the association of 3D packages with devices in libraries, schematics, and board files. Those 3D packages will not be understood (or retained) with this version.